Table of Contents
Advertisement
POINT
POINT
POINT
Selection of the RS-232 connection, RS-422 connection, or Ethernet connection
The Handy GOT can be connected to a controller in either of the RS-232 connection, RS-422 connection, or
Ethernet connection.
Select the RS-232 connection, RS-422 connection, or Ethernet connection by using the cable connector for the
PLC communication in the environmental protection back cover.
For the RS-232 connection, connect the PLC communication cable connector with the RS-232 connector.
For the RS-422 connection, connect the PLC communication cable connector with the RS-422 connector.
For the Ethernet connection, connect the PLC communication cable connector with the Ethernet connector.
The available connection type differs depending on the external cable to be used.
GT14H-C-42P: Ethernet connection
GT11H-C-37P: RS-232 connection and RS-422 connection
GT11H-C:
RS-232 connection and RS-422 connection
(The Ethernet connection is selected at factory shipment.)
For switching between the RS-232 connection and RS-422 connection at the Ethernet connection, make sure to
turn off the Handy GOT power before disconnecting or connecting the cable connector for PLC communication in
the environmental protection back cover.
Disconnecting or connecting the cable connector without turning off the Handy GOT power causes a failure. The
selected connection method (RS-232 connection or RS-422 connection) at the Ethernet connection is applied
when the Handy GOT power is turned on.
The connector can be checked through the window when the environmental protection back cover is closed.
It can be used as a method to check the connection type from the outside of the Handy GOT.
Cable connector
for PLC communication
Environmental protection
back cover window
8. COMMUNICATION CABLE
8.1 Overview of Communication Cable
1
2
3
4
5
6
7
8
8 - 3
Advertisement
Chapters
Table of Contents
