Mitsubishi Electric GT14 User Manual page 123


Installation procedure of external cable (Connector Conversion Box, GT16H-CNB-42S side)
1.
Check that the 24VDC power to the external cable is OFF.
2.
Insert the connector adjusting the triangle marks of the main unit side connector and cable side connector.
3.
After inserting the connector, push the lock lever. The connecters are locked after the lever is pushed into.

Removal procedure
1.
Check that the 24VDC power to the external cable is OFF.
2.
Pull up the lock lever with inserting a flat-blade screwdriver into the release hole of the lock lever.
3.
The external cable can be removed by pulling the whole plug connector while shifting the coupling of the plug
connector to the cable side.
Flat screwdriver
Coupling
8. COMMUNICATION CABLE
8.2 External Cable, Relay Cable
1
2
3
4
5
6
7
8
8 - 9