Mitsubishi Electric GT14 User Manual page 89


ID recognition function
GWhen connecting with controllers such as PLC via Ethernet, GT14 Handy can acquire ID number which is set by
the rotary switch of the Conversion Box of the connection target. ID number can be used as information for switching
the station number.
By storing the ID number obtained using the status observation function or the script function to the station No.
switching device, the specified connected equipment can be monitored only by connecting the Conversion Box
without specifying the station No. of the PLC.
When connected to a Connector Conversion Box
with ID number 1, the GOT monitors the PLC (A).
ID IP
1 192.168.5.50
2 192.168.5.0
IP address is
5 192.168.5.25
acquired from
the table in the
8 192.168.5.66
project.
When connected to a Connector Conversion Box
with ID number 1, the GOT monitors the PLC (B).
ID IP
1 192.168.5.50
2 192.168.5.0
IP address is
5 192.168.5.25
acquired from
the table in the
8 192.168.5.66
project.
For details of the switching the station number, refer to the following.
GT Designer3 Version1 Screen Design Manual (Fundamentals)
4.10 Station No. Switching Device Setting
POINT POINT POINT
How to use the ID number recognition function
• GT14 Handy acquires the ID number by using the RS-232 interface built in the GT14 Handy to connect with the
connector conversion box via "MODBUS/RTU" connection.
• Only when GT14 Handy connects with the connected equipment via Ethernet, the ID recognition function is
available.
• Although GT14 Handy does not support the multi-channel function including both the RS232 connection and
the Ethernet connection, GT14 Handy can use the "MODBUS/RTU" connection and the Ethernet connection for
only when the ID recognition function is used.
GT14 Handy
ID number: 1
ID
acquisition
ID number: 2
ID number: 5
GT14 Handy
ID number: 8
ID
acquisition
(A)
192.168.5.50
(B)
192.168.5.66
(C)
192.168.5.25
6. OPTION
6.6 Connector Conversion Box
1
2
3
4
5
6
7
8
6 - 17