Set Time Switch - Mitsubishi Electric F930GOT-BWD Operation Manual

Graphic Operation Terminal GOT-F900
14.2

SET TIME SWITCH

Set the time switch using the clock function built in to the GOT.
This function turns ON up to 8 consecutive bit devices during a set time when a specified day
of the week and time have come.
Target bit devices can be specified using FX-PCS-DU/WIN-E.
(In the case of GT Designer, this function is available for SW4D5C-GOTR-PACK(A) or later.)
u u u u Basic operation
OTHER MODE
screen is displayed.
Paragraph 7.3
Day of the week : Select desired days of the week by pressing them."l" is added to selected
START TIME
END TIME
< Example >
[ OTHER MODE
MENU ]
[ SET TIME SWITCH ]
a) Target bit devices
Specify up to 8 consecutive devices.
• In the setting on screen 2, (CH1) M100 will remain ON from 10h 11m 12s to 10h 12m
12s on Monday to Friday.
SET TIME SWITCH
Select "SET TIME
SWITCH".
days of the week.
When a day of the week marked with "l" is pressed again, selection is
canceled.
: Set the time at which the specified bit devices turns ON. The devices will
remain ON from the start time to the end time on the selected days of the
week.
: If the end time is earlier than the start time, the specified bit devices remain
ON until the following day (even if the following day is not selected).
Screen1
END
CH1 CH5
CH2 CH6
CH3 CH7
CH4 CH8
CH1 to CH8
Select channels
(= bit devices)
1 to 8 to be set.
Screen 1
[ CHANNEL ]
[ SET TIME SWITCH ]
CH1:
a)
SUN
START TIME
END TIME
5
0
Channel setting
screen is displayed.
Screen 2
Screen2
END
MON TUE WED THU FRI SAT
10h 11m 12s
10h 12m 12s
6 7 8 9 - CLR
1 2 3 4 ENT
Other Mode 14
14-2