Led Settings Of Grip Switch; Keylock Switch (2-Position Sw) - Mitsubishi Electric GOT2000 Series User Manual

9.4.10

LED settings of grip switch

Grip switches (DSW1, DSW2) contain green LED for checking operation.
The grip switch LED coordinates with b6 of the external input and output function/output information (read device +1) and
operates the LED ON/OFF display.
■1. Allocation of device to control LED
The device to control LED is allocated by the drawing software.
The external input and output function/output information (read device +1) set in [read device] of [system information
function] in the [common settings] is allocated to the LED control.
The LED control for the grip switch is allocated to b6 (7th bit from the lower) of the device allocated to the external input
and output function/output information.
The LED is lit when the bit value is 1 and notlit when the bit value is 0.
• External input and output function/output information (read device +1)
b15 b14 b13
For example, when D100 is set in the read device of system information, the value in b6 of D101 is reflected to the
LED lit/not lit.
9.4.11

Keylock switch (2-position SW)

The keylock switch (2-position SW) is used with wiring to the input of PLC
■1. Connection example
The following describes the connection example when the notch of the switch is set to the left.
Set the load up to 24VDC/1A (contact specification) for each contact.
■2. Pin layout
Model name
Connector Conversion Box
9 - 20
9.4 Switch Wiring
b12 b11 b10 b9
Handy GOT
Notch of
the switch is
set to the left
KSW-C
KSW-C
Terminal block 2
8
b8 b7 b6
Grip switch
KSW-1
KSW-2
Terminal No.
KSW-1
Terminal block 2
9
b5 b4 b3
Connector
conversion box
Terminal
block 2
8
9
10
Terminal block 2
b2 b1 b0
PLC
COM
X20
X21
KSW-2
10