Registration Loop Adj - Konica Minolta bizhub C360 Service Manual

Field Service Ver. 2.1 Feb. 2012
(2) Main Scanning (Front) / Main Scanning (Back)
1. Place the chart in the document feed tray (with the side having an arrow facing up).
2. Make a full size copy of the chart.
NOTE
• In the same way place the chart with the blank side facing up in the document feed
tray in the duplex mode and make a copy. Check the difference in the widths of a
between the chart and the second sided surface of the copy sample.
3. Check that the difference in the widths of A between the chart and the copy sample falls
within the specified range.
Specification A: 0 ± 2.0 mm
Adjustment range: -4.4 mm to +4.4 mm (1 step: 0.1 mm)
2
4. Call the Service Mode to the screen.
5. Touch [ADF] → [Original Stop Position].
6. Touch [Main Scanning (Front)] or [Main Scanning (Back)].
7. Enter the value from the ten-key pad. (Press the [+/-] key to change the +/- code.)
If the difference in the widths of A is greater than the specifications, enter the + value.
If the difference in the widths of A is smaller than the specifications, enter the - value.
8. Touch [END].
9. Touch [Exit] on the Service Mode screen.
10. Turn OFF the main power switch, wait for 10 sec., then turn the switch ON.
11. Make a copy of the chart again and check that the difference in the widths of A falls
within the specified range.
12.14.2

Registration Loop Adj.

<Use>
• To adjust the length of the loop to be formed in paper before the registration rollers.
• When an original misfeed or skew occurs.
<Procedure>
The default setting is 0.
Adjustable range: -5 mm to + 5 mm (in 1-mm increments)
1. Call the Service Mode to the screen.
2. Touch [ADF] → [Registration Loop Adj].
3. Select either [1-Side] or [Second Side] for the adjustment.
4. Press the clear key and change the setting value using the 10-key pad. (Press the [+/-]
key to change the +/- code.)
The amount of loop increases by the amount of positive (+) value and decreases by the
amount of negative (-) value.
5. Touch [END].
6. Touch [Exit] on the Service Mode screen.
7. Turn OFF the main power switch, wait for 10 sec., then turn the switch ON.
A
12. SERVICE MODE
A0P0F3C600DA
487
2