4.14 Adf Check; Original Stop Position; Registration Loop; Auto Adjust Stop Position - Konica Minolta Bizhub C350 Service Manual

TECH. REP. MODE

4.14 ADF Check

☞
For details, see DF-601 Service Manual
4.14.1

Original Stop Position

Functions • To make a manual adjustment of the document stop position and scanning position in
each of the ADF modes.
Use • When "Auto Adjust Stop Position" is NG.
4.14.2

Registration Loop

Functions • To adjust the length of the loop to be formed in paper before the Registration Rollers.
Use • When a document misfeed or skew occurs.
4.14.3

Auto Adjust Stop Position

A. FD 1-Sided
Functions • Adjust the document stop position for the first side.
• Check for skew.
Use • Upon setup of the ADF
B. FD 2-Sided
Functions • Adjust the document stop position for the second side.
Use • Upon setup of the ADF
C. CD
Functions • Adjust the start position for image scanning
Use • Upon setup of the ADF
4.14.4

Paper Passage

Functions • To check for paper passage through the ADF in each of the ADF modes.
Use • Used for checking the document path for any abnormal condition when a document
misfeed occurs.
4.14.5

I/O Check

Functions • To check sensors on the paper path.
Use • When a document misfeed occurs.
4.14.6

Tray Width Adjust

Functions • To set the maximum and the minimum width for the width sensor.
Use • When a document misfeed occurs.
• When an original size is erroneously detected
bizhub C350 Field Service Ver 2.0 April 2004
3-94