Punch Option Setting; 12.16.10 Job Separator - Konica Minolta bizhub C360 Service Manual

12. SERVICE MODE
12.16.9

Punch Option Setting

A. Use
• Specifies punch settings depending on the optional punch kit attached to the finisher.
• An individual punch setting needs to be made according to the type of the punch option.
B. Procedure
1. Call the Service Mode to the screen.
2. Touch [Finisher] → [Punch Option Setting].
3. Touch [PK-517].
4. Touch [2-Holes/3-Holes], [2-Holes/4-Holes], [EU4 holes] or [SWE4 holes].
5. Touch [decision].
6. Touch [END].
7. Touch [Exit] on the Service Mode screen.
8. Turn OFF the main power switch. Then, wait for 10 sec. or more and turn ON the main
power switch.

12.16.10 Job Separator

A. Use
• Checks the job separator's operation.
B. Procedure
1. Call the Service Mode to the screen.
2. Touch [Finisher] → [Job Separator].
3. Select the mode where you wish to check the operation.
4. Press the Start key to start job separator operation.
5. Press the Stop key to stop ongoing job separator operation.
504
Field Service Ver. 2.1 Feb. 2012