Konica Minolta bizhub C360 Service Manual page 215

7. FIRMWARE REWRITING
Error code
Control panel
0x00111000 Error concerning the network
• Connection has been completed.
0x00111001 Error concerning the network
• It cannot be connected to the server.
0x00111100 Error concerning the network
• Communication timeout.
0x00111101 Error concerning the network
• Disconnection occurred.
0x00111110 Error concerning the network
• The network is not connected.
0x00110010 Error concerning the network
• Others
0x00001### FTP error
• Reply code when it failed to be
connected.
0x00002### FTP error
• Error reply code for the user command
or pass command.
0x00003### FTP error
• Error reply code for CWD command.
0x00004### FTP error
• Error reply code for the TYPE com-
mand.
0x00005### FTP error
• Error reply code for the PORT
command.
0x00006### FTP error
• Error reply code for the PASV
command.
0x00007### FTP error
• Error reply code for the RETR
command.
0x10000100 • It cannot be accepted because of the
job currently being executed.
• ISW being executed by other method.
0x10000101 • It cannot be accepted because the sub
power switch is OFF.
0x10000102 • The Internet ISW is already being
executed.
160
Description
Field Service Ver. 2.1 Feb. 2012
Countermeasure
• Check the User's network environment.
(LAN cable's connection)
• Check the status of the following set-
ting.
[Service Mode] → [Internet ISW] →
[Transfer access setting]
• Check to see if the FTP server oper-
ates normally.
• Check the network environment of the
User.
• Check to see if the FTP server oper-
ates normally.
• Check the network environment of the
User.
• Check to see if the FTP server oper-
ates normally.
• Check to see if FTP server normally
operates.
• Check the IP address, user's name,
etc.
• Check to see if FTP server operates
normally.
• Check to see if FTP server operates
normally.
• Check to see if FTP server operates
normally.
• Set the PASV mode to "Invalid", and try
it again.
• Check to see if FTP server operates
normally.
• Wait for about 30 minutes and try it
again.
• Wait for the current job to be completed
and try it again.
• Turn sub power switch ON and try it
again.
• Wait for the current Internet ISW to be
completed.