Konica Minolta bizhub C360 Service Manual page 280

Field Service Ver. 2.1 Feb. 2012
(3) Leading Edge Adjustment (Duplex Side 2)
• It will not be displayed when the following setting shows that management device 1 is
mounted during the device power is OFF or no authentication is set.
[Service Mode] → [Billing Setting] → [Management Function Choice]
• This menu is unavailable when the key counter is not inserted while only the key counter
is set to Set by [Service Mode] → [Billing Setting] → [Management Function Choice].
<Use>
• Makes an adjustment by changing the image write start position in the sub scan direction
on the 2nd side of duplex printing for individual types of paper.
• When the 2nd side image on paper fed from the tray is shifted in the sub scan direction.
• Able to make an individual adjustment for each paper type of plain paper, thick 1/1+, thick
2 and thick 3.
<Procedure>
• Width A on the test print produced should fall within the following range.
• For measurement, use the image produced on the backside of the test print.
Specifications: 4.2 ± 0.5 mm
Setting range: -3.0 mm to +3.0 mm (in 0.2 mm increments)
1. Call the Administrator Settings to the screen.
2. Touch [System Settings] → [Expert Adjustment] → [Printer Adjustment] → [Leading
Edge Adjustment (Duplex side 2)].
3. Select the [Normal].
4. Press the Start key to let the machine produce a test print.
5. Check the dimension of width A on the test print.
6. If width A falls outside the specified range, change the setting using the [+] / [-] key.
If width A is longer than the specifications, make the setting value smaller than the cur-
rent one.
If width A is shorter than the specifications, make the setting value greater than the cur-
rent one.
7. Press the Start key to let the machine produce a test print.
8. Check the dimension of width A on the test print
9. If width A is outside the specified range, change the setting again and make a check
again.
10. If width A falls within the specified range, touch [OK].
11. Following the same procedure, adjust for thick 1 to 3.
Width A
Backside
10. UTILITY
A0P0F3C503DA
225