Konica Minolta bizhub C360 Service Manual page 353

10. UTILITY
C. SNMP v1/v2c Settings
(1) Use
• To conduct setting when using SNMP v1/v2c.
• To use when entering the community name for reading the Management Information
Base (MIB) and writing to it.
(2) Procedure
<Read Community Name Settings>
• Enter a read community name.
<Write Setting>
• The default setting is Enable.
NOTE
• [Enable] cannot be selected when the following setting is set to "ON."
[Administrator Settings] → [Security Setting] → [Enhanced Security Mode]
<Write Community Name Settings>
• Enter a write community name.
D. SNMP v3 Settings
(1) Context Name Settings
<Use>
• Set the context name which is used for SNMP v3.
<Procedure>
1. Touch [Name].
2. Enter the context name (up to 64 characters) on the on-screen key board, and touch
[OK].
(2) Discovery User Permissions
<Use>
• To set whether or not to enable the discovery authority user which is used for SNMP v3.
<Procedure>
• The default setting is ON.
(3) Discovery User Name Settings
<Use>
• To set the name of the discovery authority users which is used for SNMP v3.
<Procedure>
1. Touch [Discovery User Name].
2. Enter the discovery user name (up to 32 characters) on the on-screen keyboard, and
touch [OK].
NOTE
• The user name same with the read user name or the write user name cannot be
set.
298
"Enable"
"ON"
Field Service Ver. 2.1 Feb. 2012
Disable
OFF