Konica Minolta bizhub C360 Service Manual page 281

10. UTILITY
(4) Centering (Duplex 2nd Side)
• It will not be displayed when the following setting shows that management device 1 is
mounted during the device power is OFF or no authentication is set.
[Service Mode] → [Billing Setting] → [Management Function Choice]
• This menu is unavailable when the key counter is not inserted while only the key counter
is set to Set by [Service Mode] → [Billing Setting] → [Management Function Choice].
<Use>
• To vary the print start position in the main scan direction for each paper source in the 2-
sided mode.
• The image on the backside of the 2-sided copy deviates in the main scan direction.
<Procedure>
• Width A on the test print produced should fall within the following range.
• For measurement, use the image produced on the backside of the test print.
Specifications: 3.0 ± 0.5 mm
Setting range: -3.0 mm to +3.0 mm (in 0.2 mm increments)
1. Call the Administrator Settings to the screen.
2. Touch [System Settings] → [Expert Adjustment] → [Printer Adjustment] → [Centering
(Duplex 2nd Side)].
3. Select the paper source to be adjusted.
4. Press the Start key to let the machine produce a test print.
5. Check the dimension of width A on the test print.
6. If width A falls outside the specified range, change the setting using the [+] / [-] key.
If width A is longer than the specifications, make the setting value smaller than the cur-
rent one.
If width A is shorter than the specifications, make the setting value greater than the cur-
rent one.
7. Press the Start key to let the machine produce a test print.
8. Check the dimension of width A on the test print on the backside of the copy.
9. If width A is outside the specified range, change the setting again and make a check
again.
10. If width A falls within the specified range, touch [OK].
11. Following the same procedure, adjust for all other paper sources.
(Use A4 or 8 / × 11 plain paper for the manual bypass tray.)
1
2
226
Width A
Backside
Field Service Ver. 2.1 Feb. 2012
A0P0F3C504DA