System Settings-Expert Adjustment - Konica Minolta bizhub C360 Service Manual

10. UTILITY
10.6.7

System Settings-Expert Adjustment

• It will not be displayed when the following setting shows that vendor 2 is mounted.
[Service Mode] → [Billing Setting] → [Management Function Choice]
(It will be displayed when the Key Counter is mounted or when the following setting
shows that switch No.33 is set to [01] at HEX assignment.
[Service Mode] → [System 2] → [Software Switch Setting])
A. AE Level Adjustment
(1) Use
• To set the default setting for AE (Auto Exposure) the larger the value becomes the more
emphasized the background will be.
To make the background level foggier
To make the background level less foggy : Decrease the setting value
(2) Procedure
• The default setting is 2.
B. Printer Adjustment
(1) Leading Edge Adjustment
• It will not be displayed when the following setting shows that management device 1 is
mounted during the device power is OFF or no authentication is set.
[Service Mode] → [Billing Setting] → [Management Function Choice]
• This menu is unavailable when the key counter is not inserted while only the key counter
is set to Set by [Service Mode] → [Billing Setting] → [Management Function Choice].
<Use>
• To vary the print start position in the sub scan direction for each of different paper types
in the manual bypass tray.
• The PH unit has been replaced.
• The paper type has been changed.
• The print image deviates in the sub scan direction.
• A faint image occurs on the leading edge of the image.
• Able to make an individual adjustment for each paper type of plain paper, thick 1/1+, thick
2, thick 3, thick 4, transparencies, and envelopes.
<Procedure>
• Width A on the test pattern produced should fall within the following range.
Specifications: 4.2 ± 0.5 mm
Setting range: -3.0 mm to +3.0 mm (in 0.2 mm increments)
222
: Increase the setting value
"2" (0 to 4)
Width A
Field Service Ver. 2.1 Feb. 2012
A0P0F3C503DA