Initialization-System Error Clear; Problem Unit Isolation Set - Konica Minolta bizhub C360 Service Manual

Field Service Ver. 2.1 Feb. 2012
12.8.10

Initialization-System Error Clear

A. Use
• To reset the trouble data.
• Use to clear the [Jam], [Trouble], [Error] displays, and other improper displays.
• For details on items to be cleared, see "CONTENTS TO BE CLEARED BY RESET
FUNCTION."
See P.530
B. Procedure
1. Call the Service Mode to the screen.
2. Select the key as follows.
[System 1] → [Initialization] → [System Error Clear].
3. Press the Start key.
4. When [OK] is displayed, turn off the main power switch and turn it on again more than
10 seconds after.
12.8.11

Problem Unit Isolation Set.

2
A. Use
• Individual units and options have a set or unset setting for the problem unit isolation func-
2
tion.
• When a problem occurs, this function enables the continuous use of the units that are not
affected by separately controlling them and isolating other units that have a problem.
• The machine isolates only units that have a "set" setting.
NOTE
• The malfunction detection mechanism is not applied to units and options that are
being isolated.
• This function can be selected for the following units and options.
Tray 1, Tray 2, Tray 3, Tray 4, LCT, manual, Half-Fold/Tri-Fold Center Stapling, Staple,
Scanner, ADF
• Though Problem Unit Isolation Set. is not selected, if the specified malfunctions occur on
the above listed units or options, an alert screen appears and asks users whether to iso-
late the units or options where malfunction occurs.
See the "Trouble shooting" section for the corresponding trouble codes.
See P.578
B. Procedure
• The default setting is Unset for individual units and options.
• After changing the setting, touch [Decision] and turn the main power switch OFF and ON
to make the new setting effective.
Set
12. SERVICE MODE
"Unset"
435
2