Replacing The Feed Roller - Konica Minolta bizhub C360 Service Manual

Field Service Ver. 1.0 Jul. 2009
2.1.2

Replacing the feed roller

A. Periodically replaced parts/cycle
• Feed roller: Every 300,000 feed
NOTE
• Replace the separation roller assy, feed roller and pick-up roller at the same time.
B. Procedure
1. Remove the rear right cover. (Remove the right lower cover for 4th row.)
See P.12
2. Remove the tray3. (Remove the tray4 from 4th row.)
3. Remove the paper separation roller mounting bracket assy.
See the procedures 1 to 4 in P.3 "Separation roller assy."
[1]
[2] [3]
[1]
[2]
2. PERIODICAL MAINTENANCE PROCEDURE
[4]
A0XWF2C002DA
[2]
A0XWF2C003DA
[1]
A0XWF2C004DA
4. Remove three tabs [1], and remove
the harness cover [2].
5. Remove the harness from two wire
saddles [3].
6. Disconnect the connector [4].
7. Remove four screws [1] and remove
the feed unit [2].
8. Remove two screws [1] and remove
the mounting frame [2] for the paper
separation roller mounting bracket
assy.
5