Konica Minolta bizhub C360 Service Manual page 397

10. UTILITY
E. Print Data Capture
(1) Use
• To set whether to allow or restrict capturing the print job data.
• To be used when carrying out [Service Mode] → [System 2] → [Data capture].
(2) Procedure
• The default setting is Allow.
NOTE
• [Allow] cannot be selected when the following setting is set to "ON."
[Administrator Settings] → [Security Setting] → [Enhanced Security Mode]
F. Job Log Settings
(1) Use
• Selects whether to keep logs of operations and access made by users and service engi-
neers.
• To set whether to overwrite existing logs.
• To ensure security, this settings is used to keep logs of operations and access including
security settings changes, authentication, and job executions by users and service engi-
neers.
• Logs are saved in HDD and NVRAM.
(2) Procedure
• The default setting is No.
NOTE
• After selecting "Yes", the main power switch must be turned OFF and ON so that
the new setting takes effect.
• When ON is selected in [Administrator Settings] → [Security Settings] →
[Enhanced Security Mode], this setting is automatically set to "Yes."
<Overwrite>
• Set whether to allow or restrict overwriting existing logs when saving audit logs.
• The default setting is Restrict.
• To erase audit logs, press [Erase Job Log].
G. Restrict Fax TX
(1) Use
• To set whether or not to prohibit sending fax.
(2) Procedure
• The default setting is OFF.
342
"Allow"
Yes
Allow
ON
Field Service Ver. 2.1 Feb. 2012
Restrict
"No"
"Restrict"
"OFF"