Konica Minolta bizhub C360 Service Manual page 471

12. SERVICE MODE
(4) RAM Clear
<Use>
• To clear the following data at the center.
ID Code, Primary Setting, Date/Time Input (Time Zone), Software SW Setting and AT
Command.
• To be used for setting CS Remote Care.
• To be used for reset the every data of the center to default.
NOTE
• If RAM clear is selected during transmission, RAM clear processing will be imple-
mented at the time the transmission is completed regardless of whether it is done
properly or not.
<Procedure>
• The default setting is "Unset."
(5) Communication Log Print
<Use>
• To print out the communication log.
• Use to output and use the communication log.
<Procedure>
1. Call the Service Mode on the screen.
2. Touch [CS Remote Care].
3. Touch [Detail Setting] to access communication log print.
4. Load tray 1 or bypass tray with A4S or 8
5. Press Start key to print out the communication log.
(6) Software Switch Setting
<Use>
• To change the CS Remote Care settings.
<Procedure>
• Refer to "Software SW setting for CS Remote Care" for the setting.
See P.404
(7) Response Time Out
<Use>
• It sets the intervals for resending e-mails when transmission error occurred.
• It can be set only when [E-Mail] is selected by System Setting.
• To use when changing the intervals for resending e-mails when transmission error
occurred.
<Procedure>
• The default setting is 60 minute.
416
Set
/ x 11 paper.
1
2
"60 minute" (10 to 1440)
Field Service Ver. 2.1 Feb. 2012
"Unset"