Service Call Counter; Section Service Call; Warning; Maintenance - Konica Minolta bizhub C360 Service Manual

Field Service Ver. 2.1 Feb. 2012
12.10.3

Service Call Counter

A. Use
• To count and display how many times trouble has been detected on a trouble type basis.
• Use this feature to check how many times trouble has occurred.
NOTE
• In the service call counter list, "Reboot" shows how many times abort code (C-
FXXX) has occurred.
12.10.4

Section Service Call

A. Use
• To count and display how many times trouble has been detected during a certain period,
i.e. an interval between service visits, on a trouble type basis.
• Use this feature to check how many times trouble has occurred in a certain period, i.e. an
interval between service visits.
• By clearing the counter at the time of visit to your customer, i.e. service visit, you can
check how many times trouble has occurred since the previous visit.
To reset the counter, use [Counter Reset].
NOTE
• In the zone service call list, "Reboot" shows how many times abort code (C-FXXX)
has occurred.
12.10.5

Warning

A. Use
• To count and display how many times warning code has been detected on a warning
code type basis.
• To check the number of warning conditions detected according to the warming type
B. Procedure
• To clear the count of a counter, select the specific part and press the Clear key.
• If a counter is cleared mistakenly, press the Interrupt key, which will undo the clearing
operation.
• When a warning condition occurs, an oil mark appears at the lower left corner of the
basic screen.
• Touching the oil mark will display the warning code screen.
12.10.6

Maintenance

A. Use
• To set a count value for maintenance of any given part.
• When any given part is replaced.
B. Procedure
Maint.-Set
• Enter the maintenance counter value from the 10-key pad.
Maint.-Count
• The number of sheets that have been ejected is counted up. (1 sided: 1 count, 2 sided: 2
count)
• Pressing the Clear key will clear the count.
• If the count is cleared mistakenly, press the Interrupt key, which will undo the clearing
operation.
12. SERVICE MODE
455