Konica Minolta bizhub C360 Service Manual page 472

Field Service Ver. 2.1 Feb. 2012
(8) AT Command
<Use>
• To set the command to be issued at the time of modem initialization.
• This setting is available only when [Modem] is selected for the system setting.
<Procedure>
• Enter the command and touch [SET] to register.
(9) Notification Setting
<Use>
• To make the settings of notification to the Center that is performed under unilateral com-
munication via http.
• This setting is available only when [http2] is selected in System Setting.
<Procedure>
<Schedule>
• Set the schedule of notification to the center.
• Up to three different notification schedules can be registered.
• Select the notification cycle from [Day], [Week], or [Month].
When selecting [Day] for the notification cycle, set the Day Frequency.
When selecting [Week] for the notification cycle, set the Week Frequency and day of the
week.
When selecting [Month], set the Month Frequency and the date of the month.
<Center Notifi. Item>
• The following table shows each of the notification item keys and corresponding data.
[1] Sales count data
[2] Error count data
[3] Service count data
[4] Life count data
Life cycle data
[5] CSRC-System data
Device config data
[6] History data
NOTE
• Multiple items of data can be selected and sent at one time. However, be sure that
only EKC data cannot be sent together with other items of data.
[7] EKC data
[8] Adjustment data
[9] Coverage data
[10] Not used
[11] Not used
[12] Not used
12. SERVICE MODE
417