Printer Area-Leading Edge Adj. Side 2 (Duplex) - Konica Minolta bizhub C360 Service Manual

Field Service Ver. 2.1 Feb. 2012
12.4.6

Printer Area-Leading Edge Adj. Side 2 (Duplex)

2
A. Use
• For individual types of paper, this function allows the adjustment of the image write start
position in the sub scan direction on the 2nd side of duplex printing.
(to adjust the timing starting from the roller connection up to start of 2nd transfer output)
• This adjustment is made when the image on the 2nd side of paper deviates from the
original position in the sub scan direction.
• This adjustment can be made independently for each of plain paper, thick 1, thick 2, and
thick 3.
B. Procedure
• Width A on the test pattern produced should fall within the following range.
• For measurement, use the image produced on the backside of the test pattern.
Specifications: 4.2 ± 0.5 mm
1. Place A3 paper on the tray.
2. Call the Service Mode to the screen.
3. Touch [Machine] → [Printer Area] → [Leading Edge Adj. Side 2 (Duplex)].
2
4. Select the [Plain Paper].
5. Press the Start key to let the machine produce a test print.
6. Check the dimension of width A on the test print.
7. If width A falls outside the specified range, change the setting using the [+] / [-] key.
If width A is longer than the specifications, make the setting value smaller than the cur-
rent one.
If width A is shorter than the specifications, make the setting value greater than the cur-
rent one.
8. Press the Start key to let the machine produce a test print.
9. Check the dimension of width A on the test print.
10. If width A is outside the specified range, change the setting again and make a check
again.
11. If width A falls within the specified range, touch [END].
12. Following the same procedure, adjust for Thick paper.
Width A
Backside
12. SERVICE MODE
A0P0F3C503DA
375
2