Calling The Center From The Administrator; Checking The Transmission Log; Detail On Settings - Konica Minolta bizhub C360 Service Manual

Field Service Ver. 2.1 Feb. 2012
12.7.6

Calling the center from the administrator

• When the CS Remote Care setup is complete, the administrator can call the CS Remote
Care center.
1. Select [Administrator Settings], and touch [System Connection].
2. Touch [Admin. transmission].
3. Press the Start key.
When the setup is not complete or another transmission is being carried out, the
Admin. transmission key will not be displayed, and the transmission is not available.
NOTE
• For transmitting data of the machine by calling the center on the specified date
and time, refer to the manual for CS Remote Care center.
12.7.7

Checking the transmission log

• The transmission log list will be output to be checked.
1. Select [Service Mode] → [CS Remote Care], and touch [Detail setting].
2. Touch [Communication Log Print].
3. Load tray 1 or bypass tray with A4S paper.
4. Press the Start key to output transmission log.
12.7.8

Detail on settings

A. System Selection
(1) Use
• To select the system type for remote diagnosis.
• Use to newly build or change the system.
(2) Procedure
• Select E-Mail, Modem, or Fax.
• Fax is available only when the optional fax kit is being installed.
E-Mail1
B. ID Code
(1) Use
• To register the service ID.
• Use when registering and changing service ID.
(2) Procedure
• Enter a 7-digit code from the 10-key pad. (0000001 to 9999999)
<Registration>
• Touch ID code and enter the service ID.
• Touch [ID code] to register the ID.
• The [Detail Setting] will appear when the ID has been registered.
E-Mail2 Modem
12. SERVICE MODE
Fax http1 http2
413