Scanning Light Adjustment; 12.14.10 Mixed Original Size Adjustment; 12.15 Fax - Konica Minolta bizhub C360 Service Manual

Field Service Ver. 2.1 Feb. 2012
12.14.9

Scanning Light Adjustment

A. Use
• To adjust the scanning light of ADF.
• Used for adjusting the difference in the scanning lights between scanning from the origi-
nal glass and scanning from the ADF original glass.
B. Procedure
Adjustable range: -4 to + 4 (1 step)
1. Call the Service Mode to the screen.
2. Touch [ADF] → [Scanning Light Adjustment].
3. Select a color by pressing [Red], [Green], or [Blue].
4. Press the value using the [+]/[-] key.
NOTE
• It is recommended that the scanning light adjustment should be made by the same
steps for all the three colors of red, green, and blue.
5. Touch [END].
6. Touch [Exit] on the Service Mode screen.
7. Turn OFF the main power switch, wait for 10 sec., then turn the switch ON.

12.14.10 Mixed original Size adjustment

A. Use
• To adjust paper length detection accuracy used during paper feed in ADF mixed original
mode.
• To set the threshold for each size detection based on the length detected when feeding
standard sizes (large and small sizes).
B. Procedure
1. Call the Service Mode to the screen.
2. Touch [ADF] → [Mixed original Size adjustment].
3. Place the chart in the document feed tray (with the side having an arrow facing up).
4. Press the Start key.
5. Make sure that result is OK. Then, touch [SET].
6. Touch [END].
7. Touch [Exit] on the Service Mode screen.
8. Turn OFF the main power switch, wait for 10 sec., then turn the switch ON.

12.15 FAX

• For details, see FK-502 Service Manual.
12. SERVICE MODE
497