Konica Minolta bizhub C360 Service Manual page 406

Field Service Ver. 2.1 Feb. 2012
E. Format HDD
(1) Use
• To conduct logical formatting of HDD.
NOTE
• It is subject to logical formatting here, therefore if starting with physical format-
ting, follow as [Service Mode] → [State Confirmation] → [Memory/HDD Adj.] →
[HDD Format].
(2) Procedure
1. Touch [HDD Formatting].
2. Select [Yes] on the confirmation screen and touch [OK].
3. Turn off the main power switch and turn it on again more than 10 seconds after.
F. HDD Encryption Setting
(1) Use
• To re-set encrypting word due to exchange of NVRAM board or etc.
NOTE
• HDD formatting is required after this setting. Therefore it is necessary to retrieve
certain data from HDD in advance.
The following data will be lost after HDD formatting.
➀
Address data
➁
Authentication data : Authentication mode, user authentication setting, account track
➂
Box setting data
➃
Job history, fax transmission history
And after setting the HDD encryption key, the movie data and OCR dictionary data
2.1
need to be reinstalled as necessary since these data will be deleted by HDD for-
mat.
• If you replace the HDD due to its breakage or other reasons, you can automatically
2.1
reset the encryption key by installing a new HDD and performing the logical for-
mat.
(2) Procedure
1. Press [HDD Encryption Setting].
2. Enter encryption key (20 characters) with the keyboard on the operation panel and
press [OK].
NOTE
• Double-byte and identical characters are not acceptable.
3. Turn off the main power switch and turn it on again more than 10 seconds after.
4. Open [Administrator Settings] and conduct HDD formatting according to the instruction
appeared on the panel.
5. Turn off the main power switch and turn it on again more than 10 seconds after.
setting
: Box and text in the box, setting information of each box, box for
fax
10. UTILITY
351
2.1