Konica Minolta bizhub C360 Service Manual page 284

Field Service Ver. 2.1 Feb. 2012
(7) Media Adjustment
<Use>
• Adjust the 2nd image transfer output (ATVC) on the 1st page and the 2nd page for each
paper type.
• This function is provided to open [Transfer Voltage Fine Adj] → [2nd Transfer Adjust] of
2
Service Mode up to administrator and the fine-adjusted value is reflected in the Service
Mode setting.
• To use when the transfer failure at the trailing edge occurs.
• Pressing the [AUTO] key down activates the 2nd image transfer amperage upper and
lower limit control. In this case, the machine uses the voltage determined by the transfer
voltage control and the 2nd image transfer output fine adjustment value does not take
effect.
<Procedure>
• The default setting is 0.
1. Call the Administrator Settings to the screen.
2. Touch these keys in this order: [Expert Adjustment] → [Printer Adjustment] → [Media
Adjustment].
3. Select the side of the image (1st side or 2nd side), on which the transfer failure occurs.
NOTE
• For envelopes, OHP film and banner thick, only 1st side can be selected.
4. Select the paper type with the transfer failure.
5. Enter the new setting from the [+] / [-] keys.
To increase the ATVC value (in the direction of a foggier image),
increase the setting value.
To decrease the ATVC value (in the direction of a less foggy image),
decrease the setting value.
6. Touch [OK] to validate the adjustment value.
7. Check the print image for any image problem.
* To automatically control the 2nd image transfer output without using the 2nd image trans-
fer output fine adjustment value, press [Auto].
-8 to +7 (Step: 1)
10. UTILITY
229
2