Software Sw Setting For Cs Remote Care - Konica Minolta bizhub C360 Service Manual

12. SERVICE MODE
http (bilateral communication)
Step
14 Executing the initial transmission
1. Select [Service Mode] → [CS Remote Care], and touch [Detail Setting].
2. Touch [initial transmission] key on the right bottom of the screen to start initial transmission.
NOTE
• The initial transmission key at the right bottom of the screen will be displayed only
when the center ID and the URL address have been input.
See P.414
3. When the machine is properly connected with the center, CS Remote Care setting screen will
be displayed.
• If communication error between the machine and Center occurs, check the error code that
appears.
*1 Heart Beat is a feature that uploads a Heart Beat file to the registered web server at a
specified interval to report that the device is operating. Heart Beat files include total
counter and status information.
12.7.3

Software SW setting for CS Remote Care

NOTE
• SW bits data are written into the NVRAM every time a change is made. In case you
changed bit data by accident, be sure to restore the previous state.
A. Input procedure
1. Select [Service Mode] → [CS Remote Care] → [Detail Setting], and touch [Software
Switch Setting].
2. Touch [Switch No.], and input the switch number (two digits) using the 10-key pad.
3. Touch [Bit Assignment], and select switch bit number using the arrow keys, and input 0
or 1 using the 10-key pad.
(For setting by hexadecimal numbers, touch [HEX Assignment] key, and input using the
10-key pad or A to F keys.)
4. Touch [Fix].
NOTE
• About functions of each switch, see to "B. List of software SW for CS Remote
Care."
B. List of software SW for CS Remote Care
SW No.
01 • Dial Mode, Line for send only, Baud rate
02 • Emergency transmission, Date specified transmission, Call parts replace
date, Call drum replace date, Call regular service date (PM), Auto call on
the IC Life, Auto call of the IR shortage, Auto call on the zero reset of the
fixed parts replacement
03 • Trouble display setting, Auto call on the toner empty, Auto call on the waste
toner bottle full
04 • CS Remote Care communication mode
05 • Modem redial interval
06 • Modem redial times
07 • Redial for response time out
404
Field Service Ver. 2.1 Feb. 2012
(unilateral communication: Device to Center)
Procedure
Functions
http
Ref. Page
P.405
P.406
P.406
P.407
P.407
P.408
P.408