Konica Minolta bizhub C360 Service Manual page 366

Field Service Ver. 2.1 Feb. 2012
F. Time Adjustment Setting-Polling Interval
(1) Use
• To set a polling interval when Auto Time Adjustment is set to ON.
(2) Procedure
1. Press the Clear key.
2. Enter a polling interval within the range between 1 to 240 hours with the 10-key pad.
G. Status Notification Setting
• It will not be displayed when the following setting shows that authentication device is
mounted.
[Service Mode] → [Billing Setting] → [Management Function Choice]
• To notify status, notifications both by E-mail and by SNMP TRAP function can be set. For
E-mail, up to ten IP addresses and one IPX address can be set. For SNMP TRAP func-
tion, up to five IP addresses and one IPX can be set.
(1) Register Notification Address (IP Address)
<Use>
• To set IP addresses to which machine status notifications are sent.
• Up to 5 addresses can be registered.
<Procedure>
1. From IP address 1 to 5, select an IP address where settings are made.
2. Touch [Host Address].
3. Select [Input Host], [IPv4 Address Input] or [IPv6 Address Input] and enter a host
address.
4. Touch the Clear key and enter a port number within the range of 1 to 65535 using the
10-key pad.
5. Touch [Community Name] and enter a community name.
6. Touch [Notification Item] and set the items to be notified to [ON].
7. Touch [OK] and finish the settings.
(2) Register Notification Address (IPX Address)
<Use>
• To set IPX addresses to which machine status notifications are sent.
<Procedure>
1. Touch [IPX Address].
2. Touch [Network Address] or [Node Address] and enter an address.
3. Touch [Community Name] and enter a community name.
4. Touch [Notification Item] and set the items to be notified to [ON].
5. Touch [OK] and finish the settings.
10. UTILITY
311