12.16 Finisher; Fs-Fn Adjustment - Center Staple Position - Konica Minolta bizhub C360 Service Manual

12. SERVICE MODE

12.16 Finisher

12.16.1

FS-FN adjustment - Center Staple Position

A. Use
• Adjust the stapling position for each paper size when printing with the center staple func-
tion.
• Adjust the stapling position for each paper size when printing with the center staple func-
tion.
B. Procedure
NOTE
• After [Half-Fold Position] adjustment, make this [Center Staple Position] adjust-
ment.
1. Place five sheets of originals on the ADF.
2. Make a set of copy in the saddle stitching mode.
3. Check the amount of horizontal deviation (A) between the staple and the half fold posi-
tions on the set of copy.
Specification A: 0 ± 1.0 mm
Adjustment range: -10.0 mm to +10.0 mm (1 step: 0.1 mm)
4. If (A) is out of the specified range, make the following adjustment.
5. Call the Service Mode to the screen.
6. Touch [Finisher] → [FS-FN adjustment] → [Center Staple Position].
7. Touch the paper size where staple position is adjusted.
8. Look at the copy and adjust the staple position with the [+]/[-] key.
9. Press the Reset key.
10. Touch [Exit] on the Service Mode screen.
11. Turn OFF the main power switch, wait for 10 sec., then turn the switch ON.
12. Make another set of copy sample and check the amount of deviation (A).
498
Field Service Ver. 2.1 Feb. 2012
A
A11PF3C500DA
A11PF3C501DA