18. MALFUNCTION CODE
18.3.11
P-22: Color regist adjust failure
IDC registration sensor /MK (IDCS/MK)
IDC registration sensor/YC (IDCS/YC)
IDC registration sensor shutter solenoid (SD2)
Step
1
Slide out the imaging unit and reinstall it in position.
2
Reinstall or reconnect IDCS/MK assy or IDCS/YC assy if it is installed or connected improperly.
3
Check the vertical transport guide for installed position and correct as necessary.
4
SD2 operation check.
5
PRCB ICP2 conduction check.
6
Change PRCB.
18.3.12
P-27: Secondary transfer ATVC failure
High voltage unit (HV)
Printer control board (PRCB)
Step
1
Check roller opposed to the 2nd image transfer roller is grounded.
Clean the joint or correct if necessary.
2
Check the image transfer entrance guide for proper installation and correct if necessary.
3
Check that the spring does not come off during the pressure operation of the 2nd transfer roller
and correct if necessary.
4
Check the contact at the joint of the 2nd image transfer assy and HV. Clean the joint or correct if
necessary.
5
Change the transfer belt unit.
6
Change HV.
7
Change PRCB.
576
Field Service Ver. 2.1 Feb. 2012
Relevant parts
Printer control board (PRCB)
Action
Relevant parts
Image transfer entrance guide
2nd image transfer assy
Transfer belt unit
Action