Konica Minolta bizhub C360 Service Manual page 191

5. OTHER MAINTENANCE ITEMS
[1]
[2]
[3]
[4]
[3]
[1]
[3]
136
[1]
[2]
[3]
A0EDF2C263DA
[1]
[2]
A0EDF2C253DA
[2]
[4]
A0EDF2C264DA
Field Service Ver. 2.1 Feb. 2012
<Same for the front and the rear>
8. Put the front/rear pulleys [1] into the
shaft [2], and fix them with one screw
each [3].
NOTE
• Set the pulley at the direction as
shown in the illustration.
• Fix the pulley at the position as
shown in the illustration.
• Apply the screw lock on the screw.
<Same for the front and the rear>
9. Install the shaft [1] and the bearing
[2].
10. Install the gear [4] with the screw [3].
NOTE
• Apply the screw lock on the screw.
<Front side>
11. Run the bead side scanner drive
cable [1] from the pulley B [2] to the
pulley C [3]. Attach the bead to the
adjustment anchor [4].
NOTE
• Make the cable run inside the rear
groove of the pulley C.