Dc/Devc Lifestop; Nvram Data Backup; Operation Ban Release Time - Konica Minolta bizhub C360 Service Manual

13. ENHANCED SECURITY
13.3.5

DC/DevC Lifestop

A. Use
• To select whether or not to stop a print cycle when the drum unit/developing unit reaches
its service life.
B. Procedure
• The default setting is Stop.
13.3.6

NVRAM Data Backup

A. Use
• To backup NVRAM data in the main body to the flash memory.
• To backup current data in order to prevent data in NVRAM from being erased unexpect-
edly.
• To backup data manually. It usually makes backup every hour automatically.
• Backup data can be restored by following the specified procedure when the trouble
(CD3XX) occurred.
Refer to "TROUBLESHOOTING" for details on restoration procedure.
See P.679
B. Procedure
1. Touch [NVRAM Data Backup].
2. Touch [Start] to start making a backup.
3. Check the message [Backup is completed.], and turn main power switch OFF. Wait for
ten seconds or more and turn main power switch back ON.
13.3.7

Operation Ban release time

A. Use
• To set the time that elapses before the machine releases an access lock that is activated
after the CE password authentication.
• To set the period of time that elapses before the machine releases the access lock,
which aims to prevent the unintentional release of the access lock.
• After the CE password authentication, if the access lock is activated, the lock release
timer starts to operate by input the Stop → 0 → 9 → 3 → 1 → 7 in [Meter Count] →
[Check Details] → [Coverage Rate] after the main power switch is turned OFF and On.
When the timer reaches the time specified in this setting, the access lock is released.
B. Procedure
• The default setting is 1 (minutes).
NOTE
• When Enhanced Security Mode is set to ON in [Administrator Settings] → [Secu-
rity Settings] → [Enhanced Security Mode], the period of time that can be set in
this setting is 5 minutes or more.
512
"Stop"
"1" to 60 (minutes)
Field Service Ver. 2.1 Feb. 2012
No Stop