Field Service Ver. 2.1 Feb. 2012
12.9.8
CDD Calibration
2
A. Use
• To set whether to use the calibration adjustment value set prior to the shipping.
• To display the current calibration adjustment value.
• When CCD unit has been replaced, set to "OFF."
After replacing the CCD unit, the default generic value needs to be set since the calibra-
tion value set for each unit changes to control the differences in reading performance on
each scanner (CCD).
• The original calibration adjustment value can be disabled to address image failure and
other problems caused by individual CCD performance difference.
B. Procedure
• The default setting is ON.
NOTE
• When the setting is changed, the function becomes available by turning the main
power switch OFF and ON again.
12.9.9
LCT Paper Size Setting
A. Use
• To set the paper size for the LCT.
• Use this feature upon LCT set-up.
B. Procedure
• The default setting depends on the setting made for the applicable marketing area.
12.9.10
Line Mag Setting
2
A. Use
• To set whether to use the offset value which has been set prior to the shipping.
• To display the current magnification offset value.
• When CCD unit has been replaced, set to "OFF."
After replacing the CCD unit, the default generic value needs to be set since the magnifi-
cation offset value between the lines set for each unit changes to control the differences
in reading performance on each scanner (CCD).
• The original offset value can be disabled to address image failure and other problems
caused by individual CCD performance difference.
B. Procedure
• The default setting is ON.
NOTE
• When the setting is changed, the function becomes valid by turning the main
power switch OFF and ON again.
"ON"
A4
"ON"
12. SERVICE MODE
OFF
8
/
x 11
1
2
OFF
443
2