Konica Minolta bizhub C360 Service Manual page 694

Field Service Ver. 2.1 Feb. 2012
19.5.35 C11E0: Duplex path switching motor drive malfunction / Finisher route
change malfunction
(1) When FS-527 is installed
Duplex path switching motor (M2)
Duplex path switching sensor (PS3)
Step
Check the connector between M2-FSCB
1 PJ29 for proper connection and correct as
necessary.
Check the connector between PS3-FSCB
2 PJ11 for proper connection and correct as
necessary.
Check the connector of M2 for proper drive
3
coupling, and correct as necessary.
4 PS3 I/O check, sensor check
5 M2 operation check
6 Change M2
7 Change FSCB
(2) When JS-505 is installed
Route change motor (M3)
Route change home sensor (PS4)
Step
Check the connector between M3-JSCB
1 PJ6 for proper connection and correct as
necessary.
Check the connector between PS4-JSCB
2 PJ7 for proper connection and correct as
necessary.
Check the connector of M3 for proper drive
3
coupling, and correct as necessary.
4 PS4 I/O check, sensor check
5 M3 operation check
6 Change M3
7 Change FSCB
Relevant parts
Action
Relevant parts
Action
FS control board (FSCB)
WIRING DIAGRAM
Control signal
—
—
—
FSCB PJ11-6 (ON)
FSCB PJ29-1 to 3
—
—
JS control board (JSCB)
WIRING DIAGRAM
Control signal
—
—
—
JSCB PJ7-15 (ON)
JSCB PJ6-1 to 2
—
—
19. TROUBLE CODE
Location (Electri-
cal component)
—
—
—
FS-527 I-11
FS-527 I-12
—
—
Location (Electri-
cal component)
—
—
—
JS-505 F-4
JS-505 F-6
—
—
639