Printer Area-Leading Edge Adjustment - Konica Minolta bizhub C360 Service Manual

Field Service Ver. 2.1 Feb. 2012
12.4.4

Printer Area-Leading Edge Adjustment

A. Use
• To vary the print start position in the sub scan direction for each of different paper types.
(to adjust the timing starting from the roller connection up to start of 2nd transfer output)
• The PH unit has been replaced.
• The paper type has been changed.
• The print image deviates in the sub scan direction.
• A faint image occurs on the leading edge of the image.
• This setting can be made independently for plain paper, Thick 1, Thick 2, Thick 3, Thick
4, OHP films, and envelopes.
B. Procedure
• Width A on the test pattern produced should fall within the following range.
Specifications: 4.2 ± 0.5 mm
1. Place A3 paper on the manual bypass tray.
2. Call the Service Mode to the screen.
3. Touch [Machine] → [Printer Area] → [Leading Edge Adjustment].
4. Select the [Plain Paper].
5. Press the Start key to let the machine produce a test print.
6. Check the dimension of width A on the test print.
7. If width A falls outside the specified range, change the setting using the [+] / [-] key.
If width A is longer than the specifications, make the setting value smaller than the cur-
rent one.
If width A is shorter than the specifications, make the setting value greater than the cur-
rent one.
8. Press the Start key to let the machine produce a test print.
9. Check the dimension of width A on the test print.
10. If width A is outside the specified range, change the setting again and make a check
again.
11. If width A falls within the specified range, touch [END].
12. Following the same procedure, adjust for Thick 1 to 4, OHP film, and Enve.
Width A
12. SERVICE MODE
A0P0F3C503DA
373