Memory/Hdd Adj.-Memory Check; 12.12.10 Memory/Hdd Adj.-Compress / Decompression Check - Konica Minolta bizhub C360 Service Manual

12. SERVICE MODE
12.12.9

Memory/HDD Adj.-Memory Check

A. Use
• To check correspondence of data written to and that read from memory through write/
read check.
• If the copy image is faulty.
• The following shows the memory names that correspond to each memory where check
2
is made.
WORK0 : Standard memory (DIMM0)
WORK1 : Standard memory (DIMM1)
FILE0, 1 : Memory of ASIC200 installed in the MFP board
FILE2, 3 : Memory of ASIC200 installed in the EIF board for IC-412
FILE4, 5 : Not used.
Rough Check
• A check is made to see if the image data reading and writing are correctly made in a very
limited area.
• The progress of the check sequence is displayed in percentage.
Detail Check
• A check is made to see if the image data reading and writing are correctly made at the
addresses and buses in all areas.
• The progress of the check sequence is displayed in percentage.
B. Procedure
1. Call the Service Mode to the screen.
2. Touch these keys in this order: [State Confirmation] → [Memory / HDD Adj.] → [Mem-
ory Check].
3. Select the desired type of check, either [Rough Check] or [Detail Check].
4. Press the Start key to start the check procedure.
5. When the check procedure is completed, the results are shown on the screen.
If the check results are NG, check the memory for connection or replace the memory
with a new one.
✽ Press the Stop key to interrupt the check sequence.

12.12.10 Memory/HDD Adj.-Compress / Decompression Check

A. Use
• To check whether compression and decompression are carried out properly.
• If the copy image is faulty.
B. Procedure
1. Call the Service Mode to the screen.
2. Touch these keys in this order: [State Confirmation] → [Memory / HDD Adj.] → [Com-
press / Decompression Check].
3. Pressing the Start key will automatically start to complete a compression/decompres-
sion check sequence.
4. The check result will be displayed.
476
2
Field Service Ver. 2.1 Feb. 2012