Transfer Voltage Fine Adj-Secondary Transfer Adj; Stabilizer-Stabilization Only - Konica Minolta bizhub C360 Service Manual

Field Service Ver. 2.1 Feb. 2012
12.6.5

Transfer Voltage Fine Adj-Secondary transfer adj.

2
A. Use
• Adjust the 2nd image transfer output (ATVC) on the 1st page and the 2nd page for each
paper type.
• To use when the transfer failure at the trailing edge occurs.
• Pressing the [AUTO] key down activates the 2nd image transfer amperage upper and
lower limit control. In this case, the machine uses the voltage determined by the auto
transfer voltage control and the 2nd image transfer output fine adjustment value does not
take effect.
B. Procedure
• The default setting is 0.
* 1 step is equivalent to 100 V.
1. Call the Service Mode to the screen.
2. Touch these keys in this order: [Imaging Process Adjustment] → [Transfer Voltage Fine
2
Adj].
3. Select [Secondary transfer adj.].
4. Select the side of the image (1st side or 2nd side), on which the transfer failure occurs.
NOTE
• For envelopes, OHP film and banner thick, only 1st side can be selected.
5. Select the paper type with the transfer failure.
6. Enter the new setting from the [+] / [-] keys.
To increase the ATVC value (in the direction of a foggier image),
increase the setting value.
To decrease the ATVC value (in the direction of a less foggy image),
decrease the setting value.
7. Touch [END] to validate the adjustment value.
8. Check the print image for any image problem.
* Press [Auto] to automatically control the 2nd image transfer output without using the 2nd
image transfer output fine adjustment value.
12.6.6

Stabilizer-Stabilization Only

A. Use
• The image stabilization sequence is carried out without clearing the historical data of
image stabilization control.
• Use if an image problem persists even after gradation adjustment has been executed.
• When [Max Image Density Adj] and [Image Background Adj] of Service Mode are
2
changed.
B. Procedure
1. Call the Service Mode to the screen.
2. Touch these keys in this order: [Imaging Process Adjustment] → [Stabilizer].
3. Touch [Stabilization Only].
4. Press the Start key to start Stabilizer.
The Start key turns red and stays lit up red during the stabilizer sequence.
5. Stabilizer is completed when the Start key turns blue.
-8 to +7 (step: 1)
12. SERVICE MODE
395
2