12.10 Counter; Common Procedure; Life - Konica Minolta bizhub C360 Service Manual

Field Service Ver. 2.1 Feb. 2012

12.10 Counter

• The counter displays the counts of various counters to allow the technical representative
to check or set as necessary.
12.10.1

Common procedure

1. Touch [Counter] to show the counter menu.
2. Select the specific counter to be displayed.
3. To clear the counts of two or more counters within a group or across different groups at
once, touch [Counter Reset], select the specific counters to be cleared, and touch
[END]. Two or more counters can be selected.
(However, the [Service Call], [Service Total], and [JAM] counters cannot be selected.)
12.10.2

Life

A. Use
• To check the number of hours or times each of the different maintenance parts has been
used.
• To clear the count of each counter.
• To perform New Release in fusing unit and transfer belt unit.
• To check how many times maintenance parts have been used.
• When each of the maintenance parts is replaced.
B. Procedure
(1) Counter clear
• To clear the count of a counter, select the specific part and press the Clear key.
• If a counter is cleared mistakenly, press the Interrupt key, which will undo the clearing
operation.
• It is not possible to clear the count of the counters for the fusing unit, transfer belt unit,
imaging unit and TCR new article detection.
• For the count method of each counter, see the table "Count method of each life counter."
<Count method of each life counter>
Counter item
Fusing Unit Rotation Time
Fusing Unit Page Count
Transfer Belt Unit
Rotation Time
Transfer Belt Unit
Page Count
Transfer Roller Unit
Ozone Filter
1st.
2nd.
3rd.
4th.
Manual Tray
• Counts how many hours the fusing unit has turned.
• Counts how many sheets have been ejected. The counter increases
by 1 per every 216 mm in the sub scan direction and shows the total
count. For paper length less than 216 mm in the sub scan direction,
the counter uses 216 mm as the paper length.
• Counts how many hours the transfer belt has turned.
• Counts how many sheets have been ejected. The counter increases
by 1 per every 216 mm in the sub scan direction and shows the total
count. For paper length less than 216 mm in the sub scan direction,
the counter uses 216 mm as the paper length.
• Counts how many hours the transfer roller has turned.
• Counts how many hours the ozone filter has turned.
• Number of sheets of paper fed from tray 1
• Number of sheets of paper fed from tray 2
• Number of sheets of paper fed from tray 3
• Number of sheets of paper fed from tray 4
• Number of sheets of paper fed from the bypass
12. SERVICE MODE
Counting method
453