Konica Minolta bizhub C360 Service Manual page 285

10. UTILITY
C. Finisher Adjustment
(1) Center Staple Position
<Use>
• Adjust the stapling position for each paper size when printing with the center staple func-
tion.
• Adjust the stapling position for each paper size when printing with the center staple func-
tion.
<Procedure>
NOTE
• After half-fold position adjustment, make this center staple position adjustment.
1. Place five sheets of originals on the ADF.
2. Make a set of copy in the saddle stitching mode.
3. Check the amount of horizontal deviation (A) between the staple and the half fold posi-
tions on the set of copy.
Specification A: 0 ± 1.0 mm
Adjustment range: -10.0 mm to +10.0 mm (1 step: 0.1 mm)
4. If (A) is out of the specified range, make the following adjustment.
5. Call the Administrator Settings to the screen.
6. Touch [System Settings] → [Expert Adjustment] → [Finisher Adjustment] → [Center
Staple Position].
7. Touch the paper size where staple position is adjusted.
8. Look at the copy and adjust the staple position with the [+]/[-] key.
9. Touch [OK].
10. Make another set of copy sample and check the amount of deviation (A).
230
Field Service Ver. 2.1 Feb. 2012
A
A11PF3C500DA
A11PF3C501DA