Tel/Fax Number; Serial Number - Konica Minolta bizhub C360 Service Manual

Field Service Ver. 2.1 Feb. 2012
NOTE
• The language used in the service mode depends on the Language Selection set-
ting, and changes to the language as following table.
Language Selection
Japanese
Simplified Chinese
Traditional Chinese
Hangul
Language other than
listed above
12.8.2

Tel/Fax Number

A. Use
• To enter the tel/fax number of the service contact that will appear on the control panel
when a malfunction occurs in the machine.
• Upon setup.
B. Procedure
• Enter the tel/fax number (19 digits) from the 10-key pad.
• Use Interrupt key to enter "-."
12.8.3

Serial Number

A. Use
• To register the serial numbers of the machine and options.
• The numbers will be printed on the list output.
• To use the serial number as machine ID during CS Remote Care communication.
• Upon setup.
NOTE
• When main power switch was turned ON while the serial No. was not entered, the
message to require entering the serial No. will be displayed.
• Do not change the serial number registered in the machine. If memory data is lost
and entering the serial number is required, enter the original correct serial num-
ber. Be careful to enter the correct serial number since characters other than
alphanumeric can be also entered. CSRC communication is not available if a
wrong serial number is entered.
• The serial number of "Printer" can be checked through the following:
[Utility] → [Meter Count] → [Check Details].
B. Procedure
• Type the serial numbers.
Printer, Scanner, ADF, LCT, Sorter/FN, Duplex, Vendor, Fax1, Fax2, RU, ZU (Not used)
Service Mode
Japanese
Simplified Chinese
Traditional Chinese
Hangul
English
12. SERVICE MODE
431