Konica Minolta bizhub C360 Service Manual page 636

Field Service Ver. 2.1 Feb. 2012
Code Item
C0214 LCT shifting failure
C0215 LCT shift motor malfunc-
tion
C1004 FNS communication error • When the FS control board (FSCB) is
C1081 SD communication error
C1113 Center-staple lead edge
stopper motor malfunction
C1114 Center-staple front adjust
drive motor malfunction
Detection timing
• The shifter stop position sensor (PS11) is
not blocked even after the set period of time
has elapsed after the shift operation began
(shift to the right).
• The shifter stop position sensor (PS11) is
not blocked even after the set pulse is
detected by the shift motor pulse sensor
(PS8) after the shift operation began (shift to
the right).
• The shifter home position sensor (PS12) is
not unblocked even after the set pulse is
detected by the shift motor pulse sensor
(PS8) after the shift operation began (shift to
the right).
• The shifter home position sensor (PS12) is
not blocked even after the set period of time
has elapsed after the return operation
began (shift to the left).
• The shifter home position sensor (PS12) is
not blocked even after the set pulse is
detected by the shift motor pulse sensor
(PS8) after the return operation began (shift
to the left).
• The shifter stop position sensor (PS11) is
not unblocked even after the set pulse is
detected by the shift motor pulse sensor
(PS8) after the return operation began (shift
to the left).
• The shift motor pulse sensor (PS8) cannot
detect both edges of H/L even after the set
period of time has elapsed while the shift
motor (M4) is turning backward/forward
(raise/lower).
receiving data, a communication error is
detected.
• When a communication error is detected
between the FS control board (FSCB) and
the SD control board (SDCB).
<When FS-527+SD-509 is installed>
• The leading edge stopper home sensor
(PS45) is turned neither ON nor OFF even
after the set period of time has elapsed after
the leading edge stopper motor (M20) is
turned ON.
<When FS-527+SD-509 is installed>
• The center staple alignment home sensor/F
(PS42) is turned neither ON nor OFF even
after the set period of time has elapsed after
the center staple alignment motor/F (M24) is
turned ON.
19. TROUBLE CODE
Trouble iso-
Rank
lation
LCT B
LCT B
⎯
C
Half-Fold/ C
Tri-Fold/
Center Sta-
pling
Staple, B
Half-Fold/
Tri-Fold
Center
Stapling
Half-Fold/ B
Tri-Fold
Center
Stapling
581