Konica Minolta bizhub C360 Service Manual page 456

Field Service Ver. 2.1 Feb. 2012
Step
Using the telephone
line modem
11 Inputting the device telephone number
1. Select [Service Mode] → [CS Remote Care],
and touch [Detail Setting].
2. Touch [Machine Setting] → [Device Tele-
phone Number].
3. Input the Device telephone number using the
10-key pad and [P], [T], [W], [-].
See P.414
12 Inputting the AT com-
mand for initializing the
modem
1. Select [Service
Mode] → [CS
Remote Care] →
and touch [Detail
Setting].
2. Touch [AT Com-
mand].
3. Input AT Command.
NOTE
• Change this com-
mand only when it
is necessary.
(They do not need
to be changed in
normal condition.)
• For details on AT
command, see the
manual for the
modem.
See P.417
13 Setting the DIPSW for CS Remote Care
NOTE
• This setting is not normally necessary.
Take this step only when necessary in a
specific connecting condition.
Procedure
Using the Fax line
modem *1
Proceed to step 12.
Proceed to step 13. Setting the E-mail address
1. Select [Service Mode] → [CS Remote Care],
See P.418
2. Touch [Server for RX], and set POP3 server
3. Press [Receive], and set the E-Mail address,
4. Touch [Send], and set the SMTP server
5. Touch [TX/RX Test], and press Start key to
When selecting [E-Mail2]:
1. Select [Service Mode] → [CS Remote Care],
2. Touch [Schedule] and set the schedule of
See P.414
3. Touch [Center Notifi. Item] and set items that
See P.414
12. SERVICE MODE
Using E-mail
and touch [Server Set].
address, POP3 login name, POP3 password
and POP3 port number.
Mail Check, Connection Time Out and
APOP Authentication.
address, SMTP port number, Connection
Time Out, and APOP Authentication.
carry out a transmission/reception test. If it
fails to exchange messages, see the error
message to take necessary measure, and
try again.
and touch [Detail Setting].
periodic transmission.
will be reported to the Center.
401