Lead Edge Erase Adjustment; Adf Scan Glass Contamination - Konica Minolta bizhub C360 Service Manual

Field Service Ver. 2.1 Feb. 2012
12.4.21

Lead Edge Erase Adjustment

A. Use
• To set the leading edge erase amount of the paper.
• Upon user requests, it is possible to specify the void area where image is not printed
along the leading edge.
B. Procedure
• The default setting is 4 mm.
"4 mm"
NOTE
• When "4 mm" is selected, 4.2 mm is the actual amount to be erased in print based
on the control system of the machine.
12.4.22

ADF Scan Glass Contamination

2
A. Use
• To check the stain on the ADF original glass and display the result.
• To manually perform the pre-detection of the stain which is normally conducted when the
main/sub power switch is turned ON, recovering from the sleep/low power mode, etc.
• [ADF Scan Glass Contamination] will be conducted with the detection level set by the fol-
2
lowing setting.
[Service Mode] → [System 2] → [ADF Scan Glass Contamin. Set.] → [ADF Scan Glass
Contamin. Sensitivity]
When the above setting is set to "Not Set", "NG" will be displayed even though the pre-
detection is conducted.
B. Procedure
1. Call the Service Mode to the screen.
2. Touch these keys in this order: [Machine] → [ADF Scan Glass Contamination].
2
3. Press the start key to start the pre-detection.
4. Check to make sure that "OK" is displayed for the result.
✽ When the result says "NG", clean the glass and check again.
5 mm
12. SERVICE MODE
7 mm
389
2