Tray Printing Position: Tip - Konica Minolta bizhub C360 Service Manual

12. SERVICE MODE
12.4.9

Tray Printing Position: Tip

A. Use
• To change and adjust image printing position at vertical scanning direction by each feed.
(to adjust the timing starting from the roller connection up to start of 2nd transfer output).
It is not applicable in case the job is fed at re-feed.
• To be used when [Printer Area-leading Edge Adjustment] is not enough for full adjust-
ment (as such case that image printing position gets deviated due to pattern of each
feed.)
• Setting is available according to feed of 1st. Short (the length of paper at vertical scan-
ning direction is under 276.4 mm), 1st. Long (the length of paper at vertical scanning
direction is over 276.4 mm), 2nd/3rd/4th and manual.
• Adjustment is made for plain paper.
B. Procedure
NOTE
• [Printer Area-leading Edge Adjustment] should be made within specification.
• Image printing position at vertical scanning direction is adjusted based on the
combination value of this setting figure and [Printer Area-leading Edge Adjust-
ment] figure. In case the value is larger than +3.0mm or less than -3.0mm, the fig-
ure should be rounded to 3.0mm or -3.0mm.
• Width A on the test pattern produced should fall within the following range.
Specifications: 4.2 ± 0.5 mm
1. Call the Service Mode to the screen.
2. Touch [Machine] → [Printer Area] → [Tray Printing Position: Tip].
3. Set plain paper to the targeted tray, and select the feed tray.
4. Press the Start key to let the machine produce a test print.
5. Check the dimension of width A on the test print.
6. If width A falls outside the specified range, change the setting using the [+] / [-] key.
If width A is longer than the specifications, make the setting value smaller than the cur-
rent one.
If width A is shorter than the specifications, make the setting value greater than the cur-
rent one.
7. Press the Start key to let the machine produce a test print.
8. Check the dimension of width A on the test print.
9. If width A is outside the specified range, change the setting again and make a check
again.
10. If width A falls within the specified range, touch [END].
378
Width A
Field Service Ver. 2.1 Feb. 2012
A0P0F3C503DA