19. TROUBLE CODE
19.5.114 CA051: Standard controller configuration failure
19.5.115 CA052: Controller hardware error
19.5.116 CA053: Controller start failure
MFP board (MFPB)
Step
1
Check to see if the following setting has
been correctly made: [Service Mode] →
[System 2] → [Image Controller Setting].
If changing the setting, turn OFF the main
power switch and turn it ON again after 10
seconds or more.
2
Check the connectors of the MFP board
(MFPB) for proper connection and correct
as necessary.
3
Change MFPB
19.5.117 CC001: Vendor connection failure
MFP board (MFPB)
Step
1
Check the connector between vendor
CN34-MFPB PJ24 for proper connection
and correct as necessary.
2
Change PRCB
3
Change vendor
19.5.118 CC151: ROM contents error upon startup (MSC)
19.5.119 CC152: ROM contents error upon startup (Scanner)
19.5.120 CC153: ROM contents error upon startup (PRT)
Step
1
Check the ROM version.
2
Rewrite the firmware.
3
Replace the appropriate board.
666
Relevant parts
Action
Relevant parts
Action
Action
Field Service Ver. 2.1 Feb. 2012
WIRING DIAGRAM
Control signal
—
—
—
Coin vendor (Japan)
Coin vendor kit (North America, Europe)
WIRING DIAGRAM
Control signal
—
—
—
WIRING DIAGRAM
Control signal
—
—
—
Location (Electri-
cal component)
—
—
—
Location (Electri-
cal component)
—
—
—
Location (Electri-
cal component)
—
—
—