16. MECHANICAL ADJUSTMENT
16.2 Mechanical adjustment of the paper feed section
16.2.1
Skew adjustment of the tray 1/2
This adjustment must be made in the following case:
• To reduce paper skew that cannot be corrected by the registration loop adjust-
ment when the tray 1 or 2 is within the specifications.
1. Pull out the tray where this adjustment is made.
534
2. Load the tray with the paper.
3. Move the set of the paper guides [1]
[1]
A0EDF3C004DA
4. Remove the paper from the tray.
5. Secure the set of paper guides [1] on
[1]
A0EDF3C005DA
Field Service Ver. 2.1 Feb. 2012
until no gap is produced between the
both ends of paper and the paper
guides.
the tray using a screw (M3 x 8 mm:
V121 0308 04).