Konica Minolta bizhub C360 Service Manual page 299

10. UTILITY
J. ADF Adjustment
• It will be displayed only when the following setting is set to "Level 2."
[Service Mode] → [Enhanced Security] → [Administrator Feature Level]
(1) Centering
<Use>
• To adjust the read position in the main scanning direction.
• When the result is Unable in the [Centering Auto Adjustment].
• When ADF has been replaced.
<Procedure>
1. Place the chart in the document feed tray (with the side having an arrow facing up).
2. Make a full size copy of the chart.
3. Check that the difference in the widths of A between the chart and the copy sample falls
within the specified range.
Specification A: 0 ± 2.0 mm
Adjustment range: -4.4 mm to +4.4 mm (1 step: 0.1 mm)
2
4. Call the Administrator Settings to the screen.
5. Touch [System Settings] → [Expert Adjustment] → [ADF Adjustment] → [Centering].
6. Look at the copy and make adjustment with the [+]/[-] key.
If the difference in the widths of A is greater than the specifications, enter the [+] value.
If the difference in the widths of A is smaller than the specifications, enter the [-] value.
7. Touch [OK].
8. Make a copy of the chart again and check that the difference in the widths of A falls
within the specified range.
244
2
A
Field Service Ver. 2.1 Feb. 2012
A0P0F3C600DA