Administrator Unlocking; Engine Fw Dipsw - Konica Minolta bizhub C360 Service Manual

Field Service Ver. 2.1 Feb. 2012
13.3.8

Administrator unlocking

A. Use
• To release an access lock that is activated after an administrator password authentica-
tion.
• To release the access lock with service authority when an administrator password
authentication fails and the access lock is activated.
• When the main power switch is turned OFF and ON or the period of time set in the
Release Time Settings elapses, the machine releases the access lock that is activated
after the administrator password authentication.
In addition to these operations, this setting provides another way to release the access
lock.
B. Procedure
1. Touch [Administrator unlocking].
2. Touch [unlocking] to release an access lock.
3. When [OK] is displayed, touch [OK].
13.3.9

Engine FW DipSW

• It will be displayed when the following setting shows that switch No.59 is set to [01] at
HEX assignment.
[Service Mode] → [System 2] → [Software Switch Setting])
A. Use
• To make printer engine settings.
• The following table shows DIP switches that can be set in this machine.
Switch No.
1 • Not used
2 • Not used
3 • New Release Disable mode
4 • Not used
5 • PPM control (high-humidity environment mode) prohibit choice
6 • Not used
7 • Photo conductor setup rotation time choice
8
: • Not used
28
B. Procedure
1. Touch [Engine FW DipSW].
2. Touch the key that corresponds to the switch No. of the function to be set and check the
key is highlighted (ON state) in reverse video.
3. Touch [OK].
13. ENHANCED SECURITY
Function Ref. page
-
-
P.514
-
P.515
-
P.515
-
513