Konica Minolta bizhub C360 Service Manual page 943

6. MECHANICAL ADJUSTMENT
Y
Deviation in + (plus)
[3]
40
Y
Deviation in - (minus)
9J07F3C514DA
[1]
[2]
A01HF3C517DA
[2]
[1]
A01HF3C518DA
Field Service Ver. 1.0 Jul. 2009
3. Make copies 5 times repeatedly in
single side mode.
4. Fold all 5 sample copies as illus-
trated and check for any deviation.
Deviation on the sample will be Y.
5. Obtain the difference between the
deviation of the chart and the devia-
tion of the sample.
Difference of the deviation = Y - X
Specifications: 0 ± 2 mm
6. If the difference of the deviation does
not fall within the specified range,
perform the following adjustment.
7. Loosen the mounting screw [1] on
the right hinge viewed from the front.
8. When the difference of the deviation
is + (plus), turn the screw [2] coun-
terclockwise to adjust.
NOTE
• When turning the screw, be sure
not to raise the reverse automatic
document feeder until in an upright
position.
• When the adjusting plate [3] is set
far left, do not tighten any further.
• To prevent the adjustment screw [2]
breakage, be sure to follow the
above instructions.
9. When the difference of the deviation
is - (minus), turn the screw [1] clock-
wise to adjust.
10. After the adjustment is completed,
tighten the mounting screw [2] on
right side hinge securely with screw-
driver.