12. SERVICE MODE
B. ACS mode control change
(1) Use
• To change the 1st image transfer roller pressure/retraction operation control in ACS
mode.
• When a user makes mainly black prints, selecting 01 may allow avoiding the PC drum
wear-out caused by unnecessary rotation of color imaging units.
HEX Assignment 00 : The color print (pressed) position is set as the default position of
HEX Assignment 01 : The black print (retracted) position is set as the default position
(2) Procedure
1. Touch [Software Switch Setting].
2. Touch [Switch No.] and enter "50" with the ten-key pad.
3. Touch [HEX Assignment] and enter "00" or "01" with the ten-key pad.
4. Touch [Fix].
C. Secure Print shortcut key display in the User Box mode menu
(1) Use
• To display the [Secure Print] shortcut key in the User Box mode menu (the default setting
is not shown).
bit0-0: Does not display the shortcut key
bit0-1: Displays the shortcut key
(2) Procedure
1. Touch [Software Switch Setting].
2. Touch [Switch No.] and enter "69" with the ten-key pad.
3. Touch [BIT Assignment] and select "bit0" with [←]/[→] key.
4. Enter "0" or "1" with the 10-key pad.
5. Touch [Fix].
D. Printing on paper of nonstandard size fed from the bypass tray (AnySize mode)
(1) Use
• To enable printing only by the setting made on the printer driver when printing is
attempted on paper of nonstandard size fed by way of the bypass tray (the default setting
is the conventional operation).
bit0-0 : Conventional operation
bit0-1 : The print cycle is initiated for the paper specified on the printer driver regard-
less of the bypass tray paper setting.
(2) Procedure
1. Touch [Software Switch Setting].
2. Touch [Switch No.] and enter "69" with the ten-key pad.
3. Touch [BIT Assignment] and select "bit2" with [←]/[→] key.
4. Enter "0" or "1" with the 10-key pad.
5. Touch [Fix].
442
the 1st image transfer roller. (Default setting)
of the 1st image transfer roller.
Field Service Ver. 2.1 Feb. 2012