12.14 Adf; Original Stop Position - Konica Minolta bizhub C360 Service Manual

12. SERVICE MODE

12.14 ADF

12.14.1

Original Stop Position

A. Use
• To manually adjust the original stop position and the read position in each of the ADF
modes.
• When the result is Unable in the automatic adjustment of the original stop position.
B. Procedure
NOTE
• Before performing this adjustment, the feed zoom adjustment needs to be com-
plete.
See P.496
(1) Sub Scanning Direction 1-Side / Sub Scanning Direction 2-Side
1. Place the chart in the document feed tray (with the side having an arrow facing up).
2. Make a full size copy of the chart.
NOTE
• In the same way place the chart with the blank side facing up in the document feed
tray in the duplex mode and make a copy. Check the difference in the widths of a
between the chart and the second sided surface of the copy sample.
3. Check that the difference in the widths of B between the chart and the copy sample falls
within the specified range.
Specification B: 0 ± 2.0 mm
Adjustment range: -4.0 mm to +4.0 mm (1 step: 0.1 mm)
4. Call the Service Mode to the screen.
5. Touch [ADF] → [Original Stop Position].
6. Touch [Sub Scanning Direction 1-Side] or [Sub Scanning Direction 2-Side].
7. Enter the value from the ten-key pad. (Press the [+/-] key to change the +/- code.)
If the difference in the widths of B is greater than the specifications, enter the + value.
If the difference in the widths of B is smaller than the specifications, enter the - value.
8. Touch [END].
9. Touch [Exit] on the Service Mode screen.
10. Turn OFF the main power switch, wait for 10 sec., then turn the switch ON.
11. Make a copy of the chart again and check that the difference in the widths of B falls
within the specified range.
486
B
Field Service Ver. 2.1 Feb. 2012
A0P0F3C601DA