Misfeed Display Resetting Procedure - Konica Minolta bizhub C360 Service Manual

Field Service Ver. 2.1 Feb. 2012
JAM
JAM type
code
92-01 Duplex
pre-registra-
tion section
92-02
92-40
93-01 Duplex
transport
section
93-10
⎯
99-01 Controller JAM • Forced stop command was sent from the
17.1.1

Misfeed display resetting procedure

• Open the corresponding door, clear the sheet of paper misfed, and close the door.
Detection timing
• The sensor in front of tim. roller (PS1) is
not unblocked even after the lapse of a
given period of time after a duplex paper
feed sequence has been started.
• For the second-side feed of paper in the
duplex mode, loop forming has not been
complete before the second side of a
sheet enters the timing roller because the
rise timing of load to perform registration
is earlier than the rise timing of load to
form a loop.
• For the second-side feed of paper in the
duplex mode, the image write start signal
permit continues to be disabled for a pre-
determined period of time after the timing
of the image write start signal output.
• The duplex paper passage sensor (PS40)
is not blocked even after lapse of a given
period of time after starting of switch back.
• The paper does not unblock the duplex
paper passage sensor (PS40) even after
lapse of a given period of time after the
paper has blocked the PS40.
• In case the duplex paper passage sensor
(PS40) is blocked after main power switch
is turned ON, door and cover are opened /
closed or jam/trouble reset is done, it is
regarded as paper jam at duplex transport
section.
controller to the printer engine due to the
error in paper size, media, etc.
• Media error has occurred in both sides
printing.
17. JAM DISPLAY
Misfeed processing Ref.
location page
Right door P.568
Duplex door P.568
⎯ ⎯
547